Digital cable moca adapter12/29/2023 ![]() If not, you have two choices - either an amp at the antenna or possibly a HDHomeRun tuner on the first coax segment from the antenna without any connection to the moca coax. When the roof gets wet from rain, it will degrade further. The input signal from the antenna in the attic is usually heavily degraded due to the roof. It is 3dB of loss at each coax connection. More connections than that may require use of an amp. The usual installation for OTA would be a single coax run to the TV with only two connections (at antenna and at TV). If you can connect the antenna to the coax now, you can test to see if there is adequate signal at the TV. If you only have a couple connections for the OTA signal to pass through, you may not need an amp. My autistic son, who is addicted to Wheel of Fortune, which is unfortunately very difficult to stream, will be especially grateful if I, with your help, can figure this out. Thanks in advance to anyone who has guidance to offer. Do I need anything beyond a simple splitter to provide MOCA to the extender and and OTA signals to the TV? If so, what specific devices are needed/recommended? Finally my primary TV and the MOCA extender are co-located at the end of one coax segment. Am I better off just leaving it this way, or should I use a combiner or diplexer to join the segments that will run from the new OTA and the MOCA connection on the main router? If the latter, should I put them on the input side of the whole house splitter? What specific devices would work best?ģ. THe only thing on the input side is the cable from FIOS, which is no longer in use. Right now, all of the coax segments in my house terminate on the output side of the whole house splitter. Will the OTA antenna interfere with the MOCA extender or vice-versa?Ģ. THis leads me to the following questions:ġ. Finally, the ActionTEC extender sits right next to the TV that I want to hook up to the OTA antenna. ![]() I plan to connect my antenna in my attic via a currently unused coax segment that also runs to the box. ![]() Note that both the main modem and the Actiontec extender are both on segments of the whole hose coax cabling that are connected to the "output side of the whole-house splitter in the main panel where all of the coax runs in the house come together. From my main router I connect via MOCA to an Actiontec WCB6200Q extender in a remote part of the house - this seems to work very well. Currently my internet comes from the FIOS box on ethernet to my main router. To complete our recent cord cutting from cable TV, I need to add an OTA antenna in my attic. with a question on how to make MOCA and OTA antenna work togehter using same whole-house coax wiring ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |